The power pack with 12V Solar PVM and 12VDC 65AH SMF Battery.
Back bone network connectivity will facilitate for the interfacing of FCUs.
Solar Security Fence will interface with intelligent looping detection.
A Pulsed Electric current will be sent, about one pulse per two seconds, from an energizer so that when intruder comes in contact with energized wire it completes the circuit between fence and ground and a short, sharp but safe high voltage pulse administered.
Shock is sufficient to deter the intruder from proceeding further.
Accessories will comprise as under:
Intermediate insulators suitable for outdoor application with UV protection and suitable to withstand impulse voltage of more than 10kv.At least 10 KV on one end and tensioning arrangement at other end for tensioning of wire.
Lightening Diverter to bypass effects of induced lightning made of high grade UV treated plastic with nuts for fixing attaching the wires.
Earth Kits for retaining high moisture will be used for system and fence earthing
2.59 mm GI Wire high tensile strength as per IS 280-1972.
Electronic Loop Sensor for sensing the looping attempt in fence between two wires of same potential.
Fence Energizer
Will one independent high voltage and one low voltage zones. The specifications as under:
Out Voltage: OFF 4to 8 kV.
Output Energy: > 5 < Joules
Pulse interval: More than 1 second (normal 100 micro sec)
Pulse duration: Less than 300 micro second (normal 100 micro sec0
HV output zones: One
Input power for Energizer unit: 12V DC, < 1.5 A, nominal.
Energizer monitoring cabinet suitable for outdoor installation.
The cabinet will house:
Energizer unit (as described above)
Power pack with charger 1.5 A
Battery 12V/65 AH SMF.
Alarm will get activated if,
Cut in Fence Wires.
Looping attempts in fence.
Shorting of fence wires to ground.
Shock (equivalent to short via 1000 ohm resistor).